OpenATV Initial Setup Wizard Guide

After flashing OpenATV, you'll be greeted by the Initial Setup Wizard. This guide will walk you through all the essential configuration steps to get your receiver ready for use.

🌍 Step 1: Language & Region

1. Select your preferred interface language
2. Choose your country/region for proper time zone
3. Set up timezone and automatic time synchronization
4. Configure date and time format preferences

🌐 Step 2: Network Configuration

1. Choose between Ethernet (wired) or WiFi connection
2. For Ethernet: Select automatic (DHCP) or manual IP configuration
3. For WiFi: Scan and select your network, enter password
4. Test internet connectivity
5. Configure DNS servers (optional but recommended)

📡 Step 3: Tuner Configuration

1. Configure satellite positions (e.g., 13°E Hotbird, 19.2°E Astra)
2. Set up DiSEqC configuration if using multiple LNBs
3. Configure LNB power and 22KHz tone settings
4. Test signal strength and quality

📺 Step 4: Channel Scan

1. Choose scan type: Full scan or predefined bouquets
2. Select which satellites to scan
3. Start the automatic channel search
4. Wait for scan completion (can take 10-30 minutes)
5. Review found channels and create basic bouquets

🔧 Step 5: Basic Settings

1. Configure video output resolution (720p, 1080i, 1080p, 4K)
2. Set up audio output (HDMI, optical, analog)
3. Configure parental control if needed
4. Set up remote control type and buttons
5. Configure hard disk and recording settings

🎯 Step 6: OpenATV Specific Features

💡 Post-Setup Recommendations

• Create a full backup of your configured system
• Install essential plugins (Picons, EPG sources)
• Configure your preferred skin and interface settings
• Set up automatic software updates
• Install and configure your softcam for card sharing